google.cpom

0愛的鼓勵 0訂閱站台

 

These two inquiries are excellent inquiries and are posed all the time. Every individual who saws ought to consider how quick their saw is turning, regardless of who fabricated the sawmill.

 

I will uncover for a fact a few realities that have been attempted and demonstrated. I will likewise give a couple of fantasies that are false and have very little, if any, significance to the recipe of calculating the band speed.

 

First you ought to think about the pull of your sawmill. I will give a few rules. The explanation we consider the pull initially is the way that we really want the force to keep a consistent band sawmill speed.

 

Cutting logs resembles a weighty stacked truck pulling up a long tall slope. The truck can't pull up the slope in the most noteworthy stuff that it has or that it could use to run absolutely  metal band saw . It needs to down move to a lower (more slow) proportion to get the force level up to climb the slope. With a band sawmill it is shrewd to make the proportion for the hard draw of cutting as though we are pulling the long slope constantly.

 

While thinking about the drive, note that assuming the band sawmill has hydrodynamics and the siphon is mounted to get power from the saw motor, that you will free 5 to 10 pull. For instance a 25 hp manuel sawmill will cut quicker and more grounded than a 25 hp with a pressure driven siphon burglarizing strength from the edge.

 

On the off chance that I am making a judgment with respect to how quick to make a band sawmill I would prefer to remain in a protected zone and turn the cutting edge increasingly slow the higher force, than to turn excessively quick and have low force.

 

One more thought on band sawmills with at least 30 hp, is contact. At the point when the cutting edge surpasses 5,500 fpm it needs to manage a more significant level of erosion in the body of the edge. In the past we believed assuming we had the hp and force that we could fire up the edge and saw quicker. We in time understood this is a mix-up in light of grinding.

 

On certain sawmills we would run as high as 7,000 fpm. This caused some high grinding and when the bandsaw sharp edge ran into a few unfavorable bunches or hard places the cutting edge would cut severely. On similar sawmill we eased back the band to 5,500 and the issue with cutting vanished.

 

You could figure it would dial creation back. It really got creation and the cutting edges endured longer, all since we expanded our force and dropped grinding. At the point when contact is dropped the bandsaw edge is more steady.

 

The pull of your sawmill is the best calculate concluding how quick to turn a sawmill. There are different factors like wheel width and wheel roundness. In the rules you will see the movement of the more hp the quicker the bandsaw cutting edge can circumvent the band wheels partially and I accept you ought to be cautious while surpassing the greatest point.